Defrosting The Refrigerator Compartment; Defrosting The Freezer Compartment; Replacing The Light - Whirlpool WBC37552 A++DFCX Produktangaben

OTHER ABNORMAL APPLIANCE OPERATIONS DISPLAYED BY LEDs
In case of abnormal appliance operation, all the temperature selection LEDs will flash and one beep will sound. To
check the code alarm user have to press and hold the temperature setting Temp.°C & Reset alarm pushbuttons and
alarm code will be showing on the temperature LEDs (possible alarm codes are explained in the table below).
When this operation is released, the LEDs will flash until the fault is eliminated. If any alarm shown in the table occurs,
the fridge/freezer functions such as temperature adjustment, super freezing are not available until the fault is
eliminated.
When several alarms occur simultaneously, the alarm with the highest priority is displayed (Number 1 being the highest
priority).
Alarm
Evaporator Temperature Sensor Alarm - Freezer compartment
Evaporator Temperature Sensor Alarm - Fridge compartment
Ambient Temperature Sensor Alarm - Fridge compartment
Description: LED OFF
DEFROSTING THE REFRIGERATOR
COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase is
in progress. The defrost water is automatically run into a
drain hole and collected in a container, where it
evaporates.
DEFROSTING THE FREEZER
COMPARTMENT
The freezer should be defrosted
once or twice a year or when
excessive frost is present (3 mm
thickness). The formation of frost is
normal. The amount and rate at
which frost accumulates depends on
room conditions and how often the
door is open.
To defrost the unit, switch off the freezer compartment
or the whole appliance, depending on the model, and
remove all food products. Leave the freezer door open
to allow the frost to melt.
For appliances in figure only pull out the defrost water
drain and place a container under the drain.
When the operation is completed, put back the defrost
water drain.
Clean the inside of the freezer. Rinse and dry thoroughly.
Switch the freezer compartment, or the whole appliance,
back on and store the food inside.
D GB F NL
PRODUCT SHEET
Codification to be displayed by
temperature LEDs
Priority
LED 4
1
2
3
LED ON
E P I GR S
LED 5 LED 6
Contact the After-Sales Service and provide the alarm code.
Contact the After-Sales Service and provide the alarm code.
Contact the After-Sales Service and provide the alarm code.

REPLACING THE LIGHT

(depending on the model)
BULB's LIGHTING
Always disconnect the refrigerator from the power
supply before replacing any light bulb.
If the inside light is not working, it is necessary to:
1. Remove the light cover: put
the fingers into the side
ventilation holes (1), stretch
the cover gently and move it
upwards.
2. Check the bulb. If necessary unscrew the broken bulb
and replace it with the new one (max power of the
light bulb is given on the light cover).
3. Put on the light cover.
Do not leave the bulb
uncovered.
LED's LIGHTING
If the inside LED light is not
working, it must be replace by
service.
N DK FIN PL CZ
Action
SK H RUS BG RO
GB
CA