Preparing The Appliance For Operation - Whirlpool ADN221S Betriebsanleitung, Produktdatenblatt

Do not cover the ventilation holes at the top of the appliance – it must be a good air
•
circulation around the appliance. There should be a gap of at least 10 cm between the top of
the appliance body and any furniture that may be above it. If this requirement is not
followed, the appliance consumes more electrical energy and its compressor may overheat.
If the appliance is placed in a corner, a gap of at least 3 cm must be left between the
•
appliance body and the wall. Overall space required for use of the refrigerator. Overall
dimensions for installation of the refrigerator - see page 1, fig. 2.
The appliance must stand on a level surface and must not touch the wall. If necessary,
•
regulate the height of the appliance by adjusting the levelling feet: by turning them clockwise
– the front of the appliance rises, by turning them counter clockwise – it comes down. If the
appliance is tilted slightly backward – the doors will close by themselves.

Preparing the appliance for operation:

It is recommended to prepare the appliance for operation with a helper.
The device must only be transported in its vertical position; do not tilt any more than 30°.
•
Remove boards of foamed polystyrene from the top and the bottom of the appliance. They are
intended for transportation only. Remove adhesive tapes and open the door. In case of moving
the appliance to another place, lift its front in such a way that its supports couldn't touch the
floor.
Take out the plug with the supply cord 10 from the water tray 11 (see page 1, fig. 1)
which is placed under a compressor (this is intended for transportation only. When the
appliance is running, the cord can't be in the tray. The appliance should not be
connected to the mains until all packing and transport materials aren't removed.
Take out two supports 1 from a bag and screw them by screws 2 into marked places at the
•
back of a appliance (see page 2, fig. 6a).
Take out the cover 1 from the bag and insert the cover into the grid 2 placed under the door
•
(see page 2, fig. 6b).
It is permissible the conversion of the shelf 2. Maximum conversion of the shelves is obtained
•
by lowering front holders 1 by five step (see page 2, fig. 6c).
Once the unit has been positioned, wait for about 30 minutes before it is connected to the
•
mains.
If the device has been tilted more than 30° during transport, allow it
to stand in an upright position for at least 4 hours before it is
connected to the mains. If this is not done, the appliance compressor may
fail.
THE APPLIANCE BASIC PARTS (see page 1. fig. 1)
Blower. Opening the door,
1
the blower switches off.
2 Thermostat knob
3 Blower switch
4 ON / OFF switch for light
5 Thermometer
6 Adjustable height shelves
7 Thaw water channel cleaner
8 Advertising panel (ADN221 C)
9 LED lighting
10 Supply cord
11 Thaw water drip tray
6