Installation Instructions; Getting Started; Installation Checklist; Unpack The Refrigerator - Whirlpool WQ9 M2L Benutzerhandbuch

Getting Started

INSTALLATION CHECKLIST

Electrical Power
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Plug refrigerator into a earthed socket.
■
Doors
If doors need to be removed during installation, see the
■
"Remove and Replace Refrigerator Doors" and "Remove and
Replace Freezer Door Fronts" sections.
Doors seal completely.
■
Refrigerator is level. Adjust leveling feet so they are snug
■
against the floor.
Doors are even across the top. (Use door alignment feature if
■
necessary).
Final Checks
Remove all shipping material.
■
Set temperature controls to the recommended setting.
■
Save instructions and other literature.
■
In order to receive a more complete assistance, please
■
register your product on www.whirlpool.com.

INSTALLATION INSTRUCTIONS

Unpack the Refrigerator

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Refrigerator Delivery
A minimum door opening of 838 mm (33") is required. If door
opening is 914 mm (36") or less, then removal of doors, drawer
and hinges is required.
Cart the refrigerator from the side for all door openings.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for
cleaning or service, be sure to cover the oor with
cardboard or hardboard to avoid oor damage. Always pull
the refrigerator straight out when moving it. Do not wiggle or
"walk" the refrigerator when trying to move it, as oor
damage could occur.
Remove the Packaging
Remove tape and glue residues from surfaces before
■
turning on the refrigerator. Rub a small amount of liquid dish
detergent over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator.
Dispose of/recycle all packaging materials.
■
Clean Before Using
After you remove all of the packaging materials, clean inside of
your refrigerator before using it. See cleaning instructions in the
"Refrigerator Care" section.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
11