Troubleshooting Guide; Specifications - Vitek VT-1763 W Die Betriebsanweisung

ENGLISH

TROUBLESHOOTING GUIDE

Before applying to the service center read about the following problems:
Problem
The humidifier does not oper-
ate
Steam has an unpleasant smell
Small intensity of steam output
The remote control does not
operate
NOTE
Non-observance of rules for cleaning the unit parts from mineral deposits caused by
hard water may affect the overall performance of the unit.
In this case clean the unit and use filtered or distilled water in the future.

SPECIFICATIONS

Power supply: 220-230 V ~ 50 Hz
Power: 30 W
Water tank: 4,5 l
Water flow: >= 400 ml/h
Humidifying area up to 35 m
Timer for 12 hours
Ions output: 3.000.000 ion /cm
Ozone output: <= 0,05 PPM
Specifications subject to change without prior notice.
Service life of appliance - 3 years
GUARANTEE
Details regarding guarantee conditions can be obtained from the dealer from whom the
appliance was purchased. The bill of sale or receipt must be produced when making any
claim under the terms of this guarantee.
This product conforms to the EMC-Requirements as laid down by the Council
Directive 89/336/EEC and to the Law Voltage Regulation (73/23 EEC)
1763.indd 6 1763.indd 6
Possible cause
The unit is not plugged in
The water tank is empty
New device – it is normal
Polluted water in the water tank
Polluted nebulizer
Obstacle between the remote
control and the sensor on the
unit
Large distance between the re-
mote control and the unit
Battery is discharged
2
2
6
Solution
Plug the unit
Fill the water tank with water
Unscrew the lid of the water tank
and leave the unit for several
hours in a cool dark place
Clean the water tank
and fill it with pure water
Clean the nebulizer
Remove the obstacle for proper
operation of the remote control
Use the remote control in the op-
erating zone
Replace the battery
10.06.2010 14:12:48 10.06.2010 14:12:48