Troubleshooting - Vitek VT-1760 W Betriebsanweisung

ENGLISH
Before switching on the humidifier make sure
–
that the voltage of electric network corre-
sponds to the unit operating voltage.
Usage of the unit
1. Remove the lid (5) from the water tank (6).
2. Remove the water tank (6) from the unit body.
3. Turn over the tank (6), open the lid (9) rotating
it counterclockwise.
4. Fill the tank (6) with necessary amount of
water, close the lid (9) rotating it clockwise.
5. Place the filled water tank (6) on the unit body.
6. Insert the plug into the socket.
7. Switch on the humidifier, turning the knob (2)
clockwise, the operation indicator (12) will
become blue.
8. Set the mist release intensity turning the knob
(2).
9. You can switch on the illumination (3) by pressing
the button (1), for example, at night-time.
10. I f the water tank (6) is empty, the indicator
(12) will become red.
11. I n this case switch off the unit by setting the
knob (2) to «OFF» position, the indicator (12)
will go out, then unplug the unit. Fill the tank
(6) with water, install it to its place and switch
on the unit.
12. A fter the humidifier finishes operation, switch
it off by setting the knob (2) to «OFF» position,
the indicator (12) will go out.
Cleaning and care
Attention! Always switch off and unplug the
unit before cleaning.
•
Hard water causes the appearance of mineral
scale on the sprayer, on the inner parts of the
body and in the water tank; it leads to improp-
er operation of the humidifier and appear-
ance of white deposits on interior objects.
•
To avoid this it is necessary to clean the
sprayer weekly and change water as often as
possible, as well as to perform cleaning of the
filter-cartridge.
•
If you are not going to use the humidifier for
a long time, pour out water from the tank and
the operating chamber of the sprayer, wash
the water tank, wash and clean the operating
Failure
The operation indicator
doesn't light up, no mist
release
1760.indd 4
Weekly care
1. Once a week wash the water tank (6) and
2. Then carefully rinse them with water.
3. Add 5-10 drops of the detergent on the sprayer
Note: As a cleaning agent for the sprayer you
can use scale removal substances for kettles.
•
Filter cleaning
1. Clean the filter (8) after passing of about 500 l
2. Remove the lid (5) from the water tank (6) and
3. Turn over the tank (6), open the lid (9) rotating
4. Put the filter-cartridge (8) into a container
5. Install the filter-cartridge (8) back into the lid
Storage
•
•
•
Keep the humidifier away from children in a dry
cool place.

Troubleshooting

Possible causes Troubleshooting
No voltage, no Connect the unit to the mains.
power supply
Plug another, certainly operating appliance to
the socket to make sure that the socket works
properly.
4
chamber of the sprayer and the sprayer itself,
dry the unit and take it away for storage.
the operating chamber under the tank (6)
carefully with a neutral detergent solution.
(10); wait about 2-5 minutes. Remove the
deposit from the sprayer (10) with a brush (13).
Do not immerse the humidifier body into
water or other liquids.
water through it, and more often, if using hard
water or a white deposits appear on furniture,.
remove the tank (6) from the unit body (11).
it counterclockwise, remove the filter-
cartridge (8), rotating it counterclockwise.
with vinegar for 10 minutes, then take it out
and rinse with running water.
(9), rotating it clockwise.
If you are not going to use the humidifier for
a long time, make sure that all its parts are
dry, including the operating chamber of the
sprayer.
Do not store the unit with water in the water
tank and in the operating chamber of the
sprayer.
Clean and dry the filter-cartridge before tak-
ing it away for storage. Keep the filter-car-
tridge in a cool darkened place.
07.06.2012 11:47:06