Setup The System - Uponor Smatrix Move Kurzanleitung

Setup the system

Change the system parameter settings to setup the
system.
1 2
10 s
0h
3
1 2 3 4 5 6 7
13
14
15
16
17
18
19
20
21
22
23
24 2
0h 1
4
0h
5 6
24
U P O N O R S M AT R I X M O V E · Q U I C K G U I D E
Q U I C K G U I D E
12
11
10
9
8
7
6
5
4
3
1
24
P
AUTO
0h 2 4 6 8 10 12 14 16 18 20 22 24
N O T E !
Some system parameter settings are only
accessible during the fi rst 4 hours after
power up. This is done to prevent mistakes
after installation. If the locked system
parameter symbol is displayed, the power
to the controller has to be disconnected
and reconnected again to modify these
parameters. No settings are lost when
disconnecting or after a power failure.
The settings available while in run mode is
always accessible for change, and will not be
locked.
To enter system parameter settings:
1. Press and hold the OK button for about 10 seconds.
2. The settings icon is displayed in the top left hand
corner of the display, and the text Hot type, Cld
type, or rEv type (depending of current operating
mode) is displayed.
3. Use buttons < or > to locate a parameter (see list
below) and press OK.
Some of these parameters require other parameters
to activate them.
Menu Display Description
0 type Type of installation (heating and/
or cooling)
1 Cur Heating curve
See page 9 for more information
and a diagram
2 Hi Maximum supply temperature
(heating mode)
Lo
3 Minimum supply temperature
(heating mode)
1 Cur Cooling curve
See page 9 for more information
and a diagram
2 Hi Maximum supply temperature
(cooling mode)
Lo
3 Minimum supply temperature
(cooling mode)
4 InSt Type of system (hydraulic
installation)
5 th Not used by Move
tHty
6 Not used by Move
7 BGAP Boost function if the difference
between the supply and return
temperature is too much
8 trF1 Not used by Move
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
9