Installation - Uponor Smatrix Move Kurzanleitung

UK
A
CZ
DE
DK
EE
ES
C
FI
FR
HR
HU
IT
LT

Installation

Caution!
LV
Do not attempt to connect Uponor Smatrix
Base thermostats to the controller. They are
not suited for each other, and they may get
NL
damaged.
A. Attach the controller to the wall by using wall
NO
screws and plugs.
If the controller is installed inside a metal cabinet,
then locate the antenna outside the cabinet.
PL
B. Connect additional equipment, such as actuator(s),
circulation pump(s), temperature sensors etc, and
PT
secure them with cable clamps.
RO
RU
SE
SK
8
Q U I C K G U I D E
B
D E F
C. Check that all wiring is complete and correct:
• Actuators
• Heating/cooling switch
• Circulation pump(s)
• Temperature sensors
D. Ensure that the 230 V AC compartment of the
controller is closed and the fi xing screw is tightened.
E. Connect the power cable to a 230 V AC wall socket,
or if required by local regulations, to a junction box.
F. Setup the system (see next page)
U P O N O R S M AT R I X M O V E · Q U I C K G U I D E