Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 21
low before positioning the carrycot in the car:
BUCKLES FOR CAR SEAT BELTS
18. To fasten the two buckles to the pins located on the
ends of the carrycot (Fig. 18A), insert each buckle in the
respective pin, first pushing on the buckle (Fig. 18B)
then pulling the buckle down until you hear a click (Fig.
18C).
WARNING: Do not assemble the buckles backwards! (Fig.
18D). The carrycot is now ready to be positioned in the car.
FASTENING THE CARRYCOT IN THE CAR
19. To fasten the carrycot to the rear seat, position it at the
centre, aligned with the car seat, and fasten it using the
seat belts of the two outer seats (Fig. 19).
20. If the rear seat of your car has a 3-point seat belt in the
middle seat too, the carrycot can also be fastened to
one side using the middle seat and lateral seat, fasten-
ing it with the seat belts of these two seats (Fig. 20).
21. Pull and fasten the two seat belts in the seat's buckles
(Fig. 21). Recline the carrycot backrest completely
WARNING: Never use the carrycot in the car with the back-
rest raised! Safety is not guaranteed! Follow the steps below
on both sides:
22. Take the seat belt and make a loop (Fig. 22);
23. Take the car kit buckle and rotate the red bar of the
buckle outward (Fig. 23).
24. Insert the loop you've made with the seat belt into the
buckle (Fig. 24A – 24B) and rotate the red bar to its initial
position so that it rests inside the loop (Fig. 24C).
25. Pull the seat belt toward the retractor pressing the carry-
cot against the seat so that it is fastened well (Fig. 25A).
WARNING: Make sure that the carrycot is fitted against the
backrest and seat.
WARNING: Make sure that the belts are tensioned (Fig.
25B).
REMOVING THE CARRYCOT FROM THE CAR SEAT
Follow the steps below on both sides of the carrycot.
26. Unfasten the buckle from the carrycot pulling the buck-
le's red tab outward and pushing (Fig. 26) to release the
carrycot from the seat belt. The buckle is left fastened
to the seat belt.
WARNING: Never use the seat belt to fasten a passenger
without removing the CAR KIT buckle: it can be dangerous!
27. To remove the buckle from the belt, loosen the loop in
the belt (Fig. 27A) and rotate the red bar so that it comes
out (Fig. 27B).
FASTENING THE CARRYCOT TO THE STROLLER
Prepare the stroller to assemble the carrycot according to
the stroller's instructions.
For use with the stroller, make sure to remove the safe-
ty harnesses by reversing the order of the steps in the
CARRYCOT SAFETY HARNESSES AND COMFORT KIT section.
WARNING: The restraint system must be removed when
the product is used outside the car.
WARNING: To fasten the carrycot to the stroller structure,
remove the seat first.
28. Hold the handle in carrying position (vertical) and posi-
tion the carrycot in the vertical joints making sure that
the two vertical mechanisms are outside the carrycot
until you hear the click confirming fastening. Place the
carrycot with the foot zone turned towards the stroller
handle (Fig. 28A). To facilitate fixing the carrycot to the
stroller, the sides of the fabric are contoured indicating
the proper alignment (Fig. 28B).
WARNING: Before using, make sure that the carrycot is
properly locked on by pulling on it upwards.
REMOVING THE CARRYCOT FROM THE STROLLER
29. Position the handle in the carrying position (vertical),
pull the button on the front of the carrycot outward
(Fig. 29A) and, keeping the button raised, remove the
carrycot from the stroller structure by pulling it up (Fig.
29B).
WARNING: The fastening and releasing operations can be
carried out also with your child inside the carrycot; howev-
er, these operations may be more difficult to execute due
to the child's weight. Pay attention when carrying out the
aforementioned operations.
Important Note: The images and instructions in this man-
ual refer to a single carrycot version. Some of the compo-
nents and functions described here may vary depending
on the model purchased.

WARRANTY

The product is guaranteed against any conformity defect
in normal conditions of use as provided for by the instruc-
tions. The warranty shall not therefore apply in the case
of damage caused by improper use, wear or accidental
events. For the duration of the warranty on conformity de-
fects please refer to the specific provisions of national laws
applicable in the country of purchase.
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis