Herunterladen Inhalt Inhalt Diese Seite drucken

Parking Brake; Warranty - Chicco ALYSIA Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 23
WARNING: The child's weight can make these operations
more difficult.
HOW TO ADJUST THE LEGREST
20. The legrest has two positions. To adjust it, use the buttons
on the sides of the legrest (Fig. 20).
CANOPY
21. The stroller is equipped with a sun canopy and windshield
that can be adjusted to various positions. The seat features
two pins positioned on the sides of the backrest tube to
which the canopy can be attached. Insert the fastening
clips on the tube matching the pin with the hole (Fig. 21-
21A). Complete fitting the canopy to the seat by hooking
the 2 snap buttons on the back of the backrest (Fig. 21B). To
open and close the canopy, use the front arch (Fig. 21C). To
make sure your child is even more protected, the surface of
the hood can be increased by opening the zip between the
flaps (Fig. 21D-21E). To remove the canopy, simply unhook it
from the pins of the backrest tube and remove the buttons.
Clean the fabric parts using a wet terry towel and neutral soap.
WARNING: The canopy must be fixed to both sides of the
stroller. Ensure that the canopy is correctly fastened.

PARKING BRAKE

22. The parking brake acts on both stroller's rear wheels at the
same time. To activate the brake press down on the lever
(Fig. 22).
WARNING: Always apply the brakes whenever the stroller is
stopped. Never leave the stroller on a sloped surface, with a
child inside, even with the parking brakes engaged.
WARNING: After operating the brake lever, ensure that the
brakes are correctly engaged in both of the rear wheel units.
SWIVEL WHEELS
23. The stroller has front swivel/fixed wheels. It is recommend-
ed to use the wheels in the fixed mode on particularly
changeable surfaces. The use of the wheels in the swivel
mode is recommended in order to increase the control of
the stroller on a normal road surface. To use the front wheels
in swivel mode, push down on the lever located in front of
the wheels (Fig. 23). To lock it, push upwards returning the
lever to its original position (Fig. 23 A).
FOLDING THE STROLLER
WARNING: When opening the stroller, ensure that your child
and any other children are at a safe distance. Make sure that
during these operations the moving parts of the stroller do not
come into contact with your child. The stroller can be closed
either forward or parent facing. The instructions are the same
for both positions.
WARNING: You must remove all contents from the basket be-
fore closing the stroller, and remove the bag if it is attached to
the handle.
24. Lower the backrest by pressing the button on the back of
the canopy (Fig. 24). Operate the locking mechanism by
pressing button A and button B at the same time (Fig. 24A),
pull the locking handle (Fig. 24B) upwards – the stroller will
begin to fold on itself – until you hear the locking click (Fig.
24C).
The stroller can also be closed without the seat so it takes up
less room.
LEG COVER
25. The leg cover can be used in two different ways: it can be
placed over the bumper bar and fastened within the slots
(fig. 25) or, for the increased protection of your child, you
can pass the upper part of the leg cover under the bumper
bar and fasten it in the highest position by inserting the but-
tons in the slots at the sides of the hood (fig. 25A).
BAG
26. It is possible to attach the bag to the stroller handle using
the two buttons on the shoulder strap (Fig. 26).
WARNING: do not overload. The bag must not weight more
than 2 kg.
RAIN COVER
27. The stroller is equipped with a rain cover. Attach the rain
cover to the hood by fastening the buttons in the holes on
the hood and complete by fastening the buttons on the
straps by the wheels (fig. 27).
After use, if wet, let the rain cover dry off before folding and
storing it. The rain cover can be used both forward facing and
parent facing.
WARNING: The rain cover cannot be used on the stroller with-
out hood, as it may cause suffocation. When the rain cover is
fitted on the stroller, never leave it exposed to direct sunlight
with the child inside, as the temperature will rise considerably.
USING THE CAR SEAT AND CARRY COT
This stroller can only be fitted with the KIROS I-SIZE CLIP-ON car
seat and/or the CHICCO LIGHT NAP CLIP-ON ALYSIA carry cot,
which use the same fastening system. To fasten and release the
carry cot, read the related instructions.
WARNING: Before using the stroller with the carry cot or child
car seat, always make sure that the fastening system is properly
locked by pulling it up.
WARNING: The carry cot may only be attached to the chassis
in the parent-facing position.
USING THE STROLLER WITH CHILD CAR SEAT
The Kiros i-Size car seat, , which is equipped with the Clip-On
fitting device, can be fitted on the Alysia stroller.
Before fastening the stroller seat, remove the stroller seat.
28. Hold the seat by the handle in a vertical position and fasten
it to the frame, positioning the side slots on the metal fas-
teners (Fig. 28), paying particular attention to ensure that
it engages on both sides. You will hear a CLICK when it is
fastened correctly.
WARNING: The child car seat may only be attached to the
chassis in the parent-facing position.
WARNING: Before use, make sure that all the child car seat
fastening devices are correctly engaged. If it is not properly fas-
tened, remove it using the release buttons and repeat the step.
If you are unable to successfully lock the component contact
Chicco customer service.
29. To release the child car seat from the stroller, pull the rear
release handle first (Fig. 29) and then use the carry handle to
lift the child car seat (Fig. 29A).
WARNING: The child car seat can be fastened and unfastened
with the baby inside even if these procedures could be more
difficult due to the weight of the baby. Be very careful when
performing the steps described.

WARRANTY

The product is guaranteed against any conformity defect in
normal conditions of use as stated in the instructions.
Therefore, the warranty does not apply in the case of damage
caused by improper use, wear or accidental events. For the
duration of warranty on conformity defects, please refer to the
specific provisions of national laws applicable in the country of
purchase, where provided.
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis