Stryker 1288 Bedienungsanleitung Seite 8

• Always install the soaking caps before rinsing
and sterilizing the device. Failure to properly
tighten the soaking caps will corrode the
connector pins and void the warranty.
• To minimize galvanic corrosion, avoid soaking
dissimilar metals in close proximity.
• Avoid leaving the device in sterilization
solutions longer than necessary, as this will
accelerate normal product aging. Extension
cable life is extended by the consistent use
of a single sterilization method.
Limitations on Reprocessing
• Proper processing has a minimal effect on this
device. End of life is normally determined by
wear and damage due to use.
• Do not cross-sterilize the device. Using multiple
sterilization methods may significantly reduce
the performance of the device.
• Do not leave the device in solutions longer
than necessary. This may accelerate normal
product aging.
• Damage incurred by improper processing will
not be covered by the warranty.
Instructions
Point of Use
• Wipe excess soil from the device using
disposable paper towels.
• If an automated reprocessing method will be
used, rinse any channels in the device with 50mL
of sterile distilled water immediately after use.
Containment and Transportation
• Reprocess the device as soon as reasonably
practical following use.
• Transport the device in a tray to avoid damage.
Preparation for Cleaning
1. Disassemble the extension cable from the
camera head and the console.
2. Prepare an enzymatic detergent according
to the manufacturer's recommendations
(one ounce per gallon of tap water at
35 – 40°C).
3. Wipe the entire device with the detergent,
using a clean cloth.
4. Immerse the device in the detergent.
Inject any inside regions of the device with
50mL of the detergent solution to remove
loose debris.
4