Master/Slave" Connection; Stand-Alone Operation - Involight Slimpar710Pro Bedienungsanleitung

DMX-connections:
From a cable length of 300m or to 32 connected DMX devices, the signal should be amplified by a DMX splitter /
repeater (eg Involight DMXS4, DMXS6 or DMXS8) to ensure error-free data transmission.
IMPORTANT: The last device in a DMX chain should have a terminator connected to terminate the chain. DMX
terminators are commercially available, but can also be built yourself. A 120 ohm resistor must be soldered in an
XLR plug between the two poles (+ and -).
3.5 „Master/Slave" connection:
When you connect several devices in Master / Slave mode, the first device controls the others and allows an
automatic or music controlled and synchronized show. This feature is especially useful for launching a show
without much programming. Connect the DMX output of the master device to the DMX input of the first slave
device. Then connect the DMX output of the first slave device to the DMX input of the second slave device and so
on.

3.6 Stand-Alone operation:

The "SLIMPAR710PRO" can also be used in stand-alone mode without a controller. To do this, disconnect the
"SLIMPAR710PRO" from the controller and launch the preprogrammed program.
27