Husqvarna DS150 Bedienungsanweisung Seite 11

1. Remove the plastic covers from the top and the
bottom of the drill motor carriage.
2. Loosen the screw that holds the roller shafts.
3. Turn the top guide wheel clockwise with a flat
screwdriver. The top guide wheel moves nearer to
the driill column.
1341 - 002 - 24.10.2019
4. Turn the bottom guide wheel counterclockwise with a
flat screwdriver. The bottom guide wheel moves
nearer to the driill column.
5. Tighten the screw that holds the roller shafts.
Note: After you have tightened the roller shafts, they
must be possible to turn with the feed lever but not
by hand.
6. Use the feed lever to move the drill motor carriage
up and down. Make sure that the drill motor carriage
moves smoothly on the drill column. The roller shafts
must rotate and not move. If it is necessary, adjust
the roller shafts again.
11