Husqvarna ST 324 Bedienungsanweisung Seite 20

2. Remove the top 5/16'' bolts and lower ¼'' bolts (D)
from the 2 sides of the frame. Do not discard the
bolts.
3. Loosen but do not remove the lower 5/16'' bolts (C)
on the 2 sides of the frame.
4. Remove the auger belt (B) from the engine pulley
(A).
5. Tilt the rear section down. The front section will tilt
forward at the same time. The bottom bolt is a hinge
between the front and rear sections.
6. Put a wooden block below the hinge point to set the
product in the tilted position.
7. Move the auger brake arm and remove the auger
belt (B) from around the arm.
To install the auger belt
1. Move the auger brake arm (G) and put the auger belt
around and in the groove of the auger pulley (E).
A
G
F
CAUTION: Make sure that the belt is not
caught between the frame and auger
housing as you put the unit together.
2. Remove the wooden block from below the product.
3. Lift the handles to tilt the rear section up. The front
section will tilt back and pivot to attach the rear
section.
4. Make sure that the belt is put in the auger pulley (E)
groove correctly.
5. Install the 5/16'' bolts (C), and tighten (11-16 Nm).
6. Install the ¼'' bolts (D) and tighten (5-8 Nm).
7. Install the auger belt (B) on the engine pulley (A).
Make sure that the belt is put correctly around the
idler pulley and installed correctly in the engine
pulley groove.
20
B
C
D
E
8. Install the cable cover (F) and the 5/16" nut on the
frame.
9. Operate all controls to make sure that the auger belt
is installed correctly and that all components are
moving correctly.
To adjust the tension of the cable for
the discharge chute deflector
1. Loosen the jam nuts (B) to adjust the tension of the
cable for the discharge chute adjacent to the
adjuster turnbuckle (A).
A
2. Hold the short section and turn the long section to
increase the adjuster.
3. Adjust until the cable for the discharge chute
deflector (C) has a tight fit. Tighten the jam nuts.
To adjust the auger control cable
1. Remove the cable cover on the right hand side of the
frame (D).
2. To remove slack from the auger control cable,
unscrew the bottom jam nut (B) and tighten the top
jam nut (B) until the auger belt tension has
increased.
3. Retest the auger engagement. Repeat adjustment
as needed until only a small amount of slack remains
in the cable when the lever is disengaged.
4. Tighten the bottom jam nut to lock in the tension.
Note: You may also tension the auger belt by
adjusting the idler pulley as a secondary option. If
B
C
D
633 - 005 - 17.12.2019
B
B