Overload Cut-Out; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL CE-BC 4 M Originalbetriebsanleitung

can mean that the battery cannot be charged.
•
If the terminal clamps are connected to the
battery terminals with the wrong polarity. The
protection against swapped poles ensures
that the battery and charger do not get da-
maged. Remove the charger from the battery
and start the charging process from the
beginning again. Caution! Protection against
swapped poles is not available when the
SUPPLY program is used.
•
If there is a short-circuit between the two ter-
minal clamps (the metal parts of the clamps
come into contact with each other). The pro-
tection against short-circuits ensures that the
battery and charger do not get damaged.
5.5 Finishing charging the battery
•
Pull the plug out of the socket.
•
First disconnect the black charging cable
from the bodywork.
•
Then release the red charging cable from the
positive pole on the battery.
•
Important! In case of positive earthing, first
disconnect the red charging cable from the
bodywork and then the black charging cable
from the battery.
•
Screw or push the battery stoppers back into
position (if there are any).
Important! If the mains plug is pulled out but the
charger cables are still connected to the battery,
the charger will draw off a small amount of elec-
tricity from the battery. We therefore recommend
that you always completely remove the charger
from the battery when not in use.

6. Overload cut-out

The charger has electronic protection against
overloading, short-circuits and swapped poles
when the 12V STD, 12V AGM, 12V Winter and
12V M programs are used. One or more fi ne
fuses are also fi tted. If the fuse suff ers a defect
it must be replaced by a new fuse with the same
amp value. If necessary, please contact our cus-
tomer service center.
GB
7. Maintenance and care of the
battery
•
Ensure that your battery is always fitted se-
curely.
•
A perfect connection to the cable network of
the electrical system must be ensured at all
times.
•
Keep the battery clean and dry. Apply a thin
coating of grease to the connection terminals
using an acid-free, acid-resistant grease
(Vaseline).
•
Check the level of the acid in batteries that
are not maintenance-free versions approxi-
mately every 4 weeks and top up with distilled
water if necessary.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
The charger should be placed in a dry room
for storage. Any corrosion must be cleaned
off the charging terminals.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
- 18 -