Saeco IDEA RST Bedienung Und Wartung Seite 82

English
6.1.3.3 Automatic steam wand function
(for models with automatic steam wand only)
Press the button shown in the figure for 2 seconds to
activate the steam by means of the automatic steam wand.
Steam dispensing will automatically stop when the pre-set
temperature is reached.
Steam dispensing can be stopped at any time by pressing
the button again.
The temperature for steam dispensing end can be set
through the Beverages Setup menu 19. Autosteam. As an
alternative, the dispensing end temperature can be set by
immersing the steam wand in milk or in water to be
heated, and by pressing and holding pressed the button
shown in the figure until the desired temperature is
reached. The temperature reached when the button is
released will be stored for the following steam dispensing
cycles.
When the Auto Steam function is active, the display shows
the icon as shown in the figure.
The same icon flashes while programming temperature.
82