Setup Menu Items; Advanced Setup Menu - Yamaha CD-N301 Bedienungsanleitung

SETUP MENU

Setup menu items

Menu Submenu
Net Standby
AutoPowerStdby
System Config
Accessory
Firm Version
Firm Update
Network Status
MAC Address
Network Info
System ID
Network Name
DHCP
IP Address
Network Config
Subnet Mask
Def. Gateway
DNS Server (P)
DNS Server (S)
*1: When "DHCP" is "On", you can check the values (IP address, etc.) assigned by the DHCP server.

Advanced setup menu

The following menu items are available only when you enter the setup menu by pressing SETUP (on the remote control)
while holding down RETURN (on the main unit).
Menu
MAC Filter
Initialize
24
En
Settings
(Bold: default)
On, Off
20min, 2hours,
4hours, 8hours,
12hours, Off
On, Off
On, Off
Settings
(Bold: default)
Select "On" to specify the MAC addresses (up to 5) of the network
On, Off components that will be permitted access to this unit ("Address1" to
"Address5"). Select "Off" to disable the MAC address filter function.
Reset the all settings of this unit to factory default. To reset the settings,
press SELECT/ENTER on the front panel or ENTER on the remote
control.
The reset operation will be reflected the next time you turn on this unit.
Select "On" to enable the network standby mode.
This unit automatically enters standby mode if it is left turned
on for the selected time without playback or any other
operation being performed.
Selects whether or not to supply power to a Yamaha
accessory connected through the DC OUT jack.
The firmware version of this unit is shown.
Updates the firmware of the unit (☞ P.25).
The network status of this unit is shown ("Connected" or
"Not connected").
The MAC address of this unit is shown. The MAC address is
also used as a vTuner ID.
The system ID number is shown.
Shows the name of the unit that appears on the network.
Select "On" to use the DHCP server to automatically
configure the network settings of this unit or "Off" to
configure manually.
Specify the IP address when "DHCP" is "Off".
Specify the subnet mask when "DHCP" is "Off".
Specify the default gateway when "DHCP" is "Off".
Specify the primary DNS server when "DHCP" is "Off".
Specify the secondary DNS server when "DHCP" is "Off".
Function
Function
*1
*1
*1
*1
*1