Ready Mode; Using The Advanced Setup - Yamaha CDC600B Bedienungsanleitung

This unit is equipped with the following four special
modes, which may be useful for special purposes at stores
or offices.
Note
The special mode functions are incompatible with iPod.
Play mode memory
Retains the current playback mode (REPEAT and
RANDOM) after turning off the power, saving the time of
setting the playback mode again each time you turn on the
power.
The track number is also retained so playback starts with
the same track automatically when you turn on the power
again.
The RESUM indicator in the front panel display lights up
when enabled.

Ready mode

Pauses playback after each track, allowing you to start the
next track at any desired timing.
The RDY indicator in the front panel display lights up
when enabled.
RS-232C ON/OFF
Turns on or off the RS-232C terminal on the rear panel.
Turn it on when you use the RS-232C feature.
This mode is disabled with shipment.
Auto standby mode
When this function is enabled, this unit turns to the
standby mode automatically if any of the following
conditions lasts for 30 minitutes:
1) CD playback is stopped while in the CD mode
(including when no disc or unsupported disc is loaded).
2) CD playback is in a pause position.
3) No USB device is connected while in the iPod/USB
mode.
4) Unsupported USB device is connected while in the
iPod/USB mode (iPod/USB indicator remains lit in
orange).
Note
This unit does not turn to the standby mode automatically when a
supported USB device or iPod is connected (when iPod/USB
indicator is lit in green).

USING THE ADVANCED SETUP

To activate and configure Advanced setup, follow the
steps below. Use the buttons on the front panel.
POWER OFF
Activate
Advanced setup
PURE DIRECT +
Play mode
memory
PLAY MEM OFF
(Stop)
RDY mode
RDY MODE OFF
(Stop)
RS-232C mode
RS-232C OFF
(Stop)
AUTO
STANDBY mode
A-STANDBY ON
(Stop)
Back to Play mode memory
Store settings
(Play)
POWER OFF
Next time you turn on the power, the unit turns on with
the settings that you specified above.
(Open/Close) + POWER ON
/
PLAY MEM ON
/
/
RDY MODE ON
/
/
RS-232C ON
/
/
A-STANDBY OFF
/
*: Default setting
13
En