Concept VT 8020 Bedienungsanleitung Seite 37

EN
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
Delayed switch-on: with the appliance in the OFF position, press the timer button (D)
The display shows the symbol
To set the timer, use + and - adjustment buttons (B), then wait a few seconds for the programming to be set. The
display shows the symbol
appliance turns on with the same settings it had during the previous operation.
Delayed shut-off: with the appliance on, press the timer button (D)
time remaining before shut-off.
To set the timer, use + and – adjustment buttons (B), then wait a few seconds for the programming to be set. The
display returns to show the current settings and the symbol to indicate you have set the timer. When the pro-
grammed time has been reached the appliance shuts off automatically.
If you want to go back to operation without the timer, press the timer button (D)
pears from the display.
USING THE REMOTE CONTROL
The remote control functions are identical to those on the control panel. See the section "Operation" on the previous
page for a description of the functions.
INSERTING OR REPLACING BATTERIES
- Remove the cover on the rear of the remote control;
- Insert the button battery (model CR/2032/3V) into remote control with the positive pole (smooth side) facing up.
- Replace the cover.
- Old batteries must be removed and disposed of in accordance with current legislation as they are harmful to the
environment.
Safety Features
1. This heater includes an audible alarm to warn that parts of the heater are getting excessively hot. If the alarm
sounds, immediately turn the heater off and inspect for any objects on or adjacent to the heater that may cause
high temperature.
DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING.
2. A thermal overload protector is built-in to prevent overheating.
3. When an overheat temperature is reached, the heater will be automatically shut off. It can only resume operation
when the user resets the unit. (See RESET INSTRUCTIONS below)
Reset instructions
1. Unplug the heater and wait 20 minutes for the unit to cool down.
2. After the 20 minutes, plug the unit in again and operate normally.
Troubleshooting tips
If your heater shuts off unexpectedly or fails to operate, one of the above-mentioned safety features may have
activated to prevent overheating.
1. Be sure the power cord is plugged into a working electrical outlet.
2. Check your thermostat setting. The heater may be off because it has reached the desired temperature setting.
VT 8020
and the time remaining before switch-on.
to indicate you have set the timer. When the programmed time has been reached, the
.
. The display shows the symbol
twice. The timer symbol disap-
and the
35