Cleaning The Glass Panes - hanseatic 5022IE2.323eEHiTaDJW Gebrauchsanleitung

Cleaning the glass panes

The oven door contains three glass panels
that should occasionally be cleaned on both
sides. To do this you'll need a PH1 flat-head
screwdriver.
1. Take the oven door off its hinges (see
„Removing the oven door from its hinges"
on page EN-24).
2. Remove both screws that secure the top
metal grid.
3. Carefully removed the metal grid.
(22)
The oven
4. Remove the upper pane from the
mounts below the hinges and carefully
set it down.
5. Remove the middle pane and carefully
set it down.
6. Please ensure not to lose the small
spacers (22).
7. Clean all panes with warm, fresh water.
8. Dry the panes thoroughly.
9. Reposition the middle pane in the
mounts at the hinges.
10. Replace the spacers (22) at the sides of
the middle pane.
11. Reposition the upper pane in the mounts
at the hinges. Make sure that the smooth
side is facing outwards.
12. Put the grid plate back on top of the door
– it only fits in one direction. First insert
it on the left-hand side and then press
down on the right-hand-side until it clicks
into place.
13. Replace the oven door (see „Replacing
the oven door on its hinges" on page
EN-24).
Page EN-25