Sony XAV-7W Bedienungsanleitung Seite 14

Setting a Security Code
Tip
If the entered security code is not correct,
the indication "CODE ERR" flashes* and
the unit returns to the input standby
condition.
* "Code Error" flashes on the monitor
when the monitor is open.
Note
The security code is not erased also when
the Reset button is pressed.
14
To delete the security code
In step 2, select "Code Delete" and then proceed the
remaining steps until step 7.
Entering the security code
When a security code is set, an indication requesting input
of the security code appears on the display window when
the unit is connected to the battery after having been
disconnected from the battery for a long period of time (see
"Note" on the preceding page). Input the code with the
card remote commander as follows.
1
Press V or v to select a number.
2
Press b to move to the next digit.
3
Repeat steps 1 - 2 until all digits are input.
4
Press ENTER.
The clock indication now appears on the display window.