Connections; Before Connecting Components - Yamaha RX-V396RDS Bedienungsanleitung

Before Connecting Components

CAUTION
Never connect this unit and other components to mains power until all connections between components have been
completed.
Be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, "+" to "+" and "–" to "–". Some
components require different connection methods and have different terminal names. Refer to the instructions for each
component to be connected to this unit.
When you connect other YAMAHA audio components (such as a tape deck, MD recorder and CD player or changer), connect
it to the terminals with the same number labels as !, #, $ etc. YAMAHA applies this labeling system to all its products.
Use RCA-type pin plug cables for connecting audio/video components with the exception described later.
The input and output terminals for pin plugs can be distinguished as follows:
Yellow video signals (composite)
White analog audio signals for the left channel
Red analog audio signals for the right channel
coaxial digital signals
After completing all connections, check them again to make sure they are correct.
Connecting the Connecting to an External
Antenna (page 10) Decoder (page 12)
Connecting an Audio
Component (page 12)

CONNECTIONS

Connecting a Video
Component (page 13)
V
L
R
C
Connecting Speakers Connecting the Power
(page 14) Supply Cords (page 16)
+ – – +
R L
MAIN
A
B
REAR
L
R
CENTER (SURROUND)
+ +
– –
IMPEDANCE SELECTOR
switch (page 16)
V
L
R
C
(U.S.A. model)
MAINS
SET BEFORE POWER ON
120 V 60Hz
100W MAX. TOTAL
SWITCHED
MAIN A OR B : 4ΩMIN. /SPEAKER
A + B : 8ΩMIN. /SPEAKER
CENTER : 6ΩMIN. /SPEAKER
REAR : 6ΩMIN. /SPEAKER
MAIN A OR B : 8ΩMIN. /SPEAKER
A + B : I6ΩMIN. /SPEAKER
CENTER : 8ΩMIN. /SPEAKER
REAR : 8ΩMIN. /SPEAKER
9