Hayward Powerline PowerShark II Anwenderhandbuch Seite 26

7. After the pool has been cleaned, switch OFF the power supply before removing the cleaner from the
pool.
8. Remove the cleaner from the water at the shallow end of the pool by pulling the cable until the cleaner
reaches the surface. Then lift it out of the water using the handle, NOT the cable.
9. If the supply cord is damaged it must be replaced by the manufacturer, service agent, or similarly
Caution: When pulling the cable, reel it in hand-over-hand - do NOT reel it around your arm.
DO NOT ENTER THE SWIMMING POOL WHEN THE CLEANER IS OPERATING.
Optimum operating water temperature range for the cleaner is 10ºC - 35ºC.
Remove the cleaner from the pool after each use. Keeping the cleaner permanently in the pool may
result in additional service requirements.
POWER SUPPLY OPERATING INSTRUCTIONS
When the power supply is initially switched ON
cycle.
cleaner will automatically shut-off after 4-hours of operation on this cycle.
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Use of non genuine Hayward manufactured parts will void all warranty.