Mds-City Menu - Fermax MDS-CITY Bedienungsanleitung

1. Dial the number of the first telephone to be programmed.
D 1 2 3 4
e In Se Co Tel
2. Press the door release button in the telephone.
4. Press 'B' to finish the sequence.
This option is available only for audio decoders.

4.4. MDS-CITY Menu

Press '4' in the Main Menu to access the MDS-CITY Menu.
This menu allows to program the four operative parameters required for MDS-
CITY panels (for condominiums with several accesses):
1. Panel number (1..9).
2. Block number (0..99).
3. Conversation Time (1..3).
4. Door release Time (0..9).
For a detailed description of these parameters, read the Installation Manual
provided with the MDS-City Digitizer Module required for this type of installations.
The way to program these parameters is very similar to the one specified in
document for programming from MDS-Direct panels, with the only difference
that the guard unit uses the 'B' key to confirm the changes.
Pag 30
If using automatic mode, the MDS-CITY/DIRECT Guard Unit
will assign the following address (number) to that telephone,
staying ready to program another one (except in case the
number already existed).
Press sequentially the door release buttons of the telephones
to program consecutively.
If using manual mode, the top-line in the display will show
the current number and the bottom-line will ask us to enter
the new number. Dial the new number and confirm it with 'B'.
Repeat this step with all the telephones you want to program.