Fermax MDS-CITY Bedienungsanleitung Seite 29

Decoders Menu: 2. Sequential Programming
D 1 2 3 4
By means of this option, the decoders can also be programmed
e In Se Co Tel
sequentially, assigning consecutive numbers to the telephones
they have connected. The steps to follow are:
1. Dial the number to be assigned to the first output of the first
2. Press the programming button in that decoder (see installation
3. Press the programming button in the next decoder to be
4. Press the 'B' key to finish the sequence.
This option is available only for audio decoders.
Decoders Menu: 3. Change Code
D 1 2 3 4
e In Se Co Tel
Allows to change the number assigned to a single output in a
decoder. This can be done as follows:
1. Dial the current number and press 'B' to confirm it. If it does
2. Dial the new code and confirm it with 'B'.
This option is available only for audio decoders.
Decoders Menu: 4. Programming from Telephone
D 1 2 3 4
e In Se Co Tel
Allows to program the decoders without having acces to them
(phisically), by means of the telephones attached to the deco-
ders. This can be done in two different ways:
1: Manual. Allows to program the decoders individually. This
option requires two people to program them: one goes telephone
by telephone and the other one will stay in the outdoor panel
assigning the numbers.
2: Automatic. Allows to program the decoders sequentially, thus
only one person is needed.
In both cases, once the option is chosen, the procedure is very
similar:
decoder to programand press 'B'.
instructions provided with the decoder). The system will
automatically assign correlative numbers to the outputs.
programmed. The system will automatically assign numbers
starting from the last one programmed in previous decoder.
not exist, an error message will be shown in the display.
Otherwise, the new code will be requested.
Pag 29