Door Entry Phone Installations - Fermax MDS-CITY Bedienungsanleitung

Depending on the installation, the guard unit is operated as follows:

3.1. Door Entry Phone installations

The functionallity of the "hotkeys" keypad is:
Po Guard - Telephone Communication
Communicates the guard with a particular telephone. To do so:
1. Dial the telephone number. If the telephone to communicate with, is the last
one that has been attended it is not necessary to dial it again.
2. Press the key Po
3. The display will show the number of the telephone called. I.e. when calling
telephone 2001 the display will show: [Po/ 2001].
If the number dialed does no exist the display will show: 'Code not valid'.
Po Panel - Guard Communication
Communicates the guard with an outdoor panel. The steps to follow are:
1. Dial the panel number (2 digits) you want to communicate to. Read note in
next page. In case this panel was the last one communicated from the guard
unit, the procedure can start on step 2.
2. Press the key
display will show [ NN/Po] with the following meaning: "NN" corresponds
with the panel number (from 00 to 99). Read note in the next page.
Panel - Telephone Communication
Communicates an outdoor panel with a telephone.
By default, the panel and telephone will be the last ones communicated with
the guard. Otherwise, select the panel to communicate to, previously, by means
of the Po key and/or the telephone with the Po
The display will show [ PP/ TTTT], being PP the panel number and TTTT the
telephone number communicated. Read note in the following page.
Example: select telephone 2001, panel 01 and press the
play will show: [ 01/ 2001].
in order to select this communication channel.
Po in order to select this communication channel. The
key.
key. The dis-
Pag 23