Switching The Rear Output Setting - Pioneer KEH-P6020RB Bedienungsanleitung

Section
Initial Settings
08

Switching the rear output setting

This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer output
on (refer to Using subwoofer output on page 32).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this set-
ting.
1 Press
FUNCTION
setting mode.
Press
FUNCTION
appears in the display.
• If the rear output setting has been set to the
subwoofer then
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between
(full-range speaker) and
and that status will be displayed.
36
En
to select the rear output
repeatedly until
FRT+REAR
will be displayed.
FRT+S/W
FRT+REAR
(subwoofer)
FRT+S/W