Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Switching Auto Pi Seek - Pioneer KEH-P6020RB Bedienungsanleitung

Section

Initial Settings

08

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 display
FUNCTION
Shows the function status.
1 Press
SOURCE
off.
2 Press
FUNCTION
appears in the display.
3 Press
FUNCTION
settings.
Press
FUNCTION
the following settings:
—
FM STEP A-PI
—
ILL.CLR FRT+REAR
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down
FUNCTION
34
En
1
and hold until the unit turns
and hold until
FM STEP
to select one of the initial
repeatedly to switch between
— — —
WARN AUX DIMMER
BAND/ESC
until the unit turns off.

Setting the FM tuning step

Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA are on the tun-
ing step automatically changes to 100 kHz. It
may be preferable to set the tuning step to 50
kHz when AF is on.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 50 kHz and 100 kHz while AF or TA is
on. The selected FM tuning step will appear in
the display.
Note
• The tuning step remains at 50 kHz during
manual tuning.
—

Switching auto PI seek

The unit can automatically search for a different
station with the same programming, even dur-
.
ing preset recall.
1 Press
FUNCTION
Press
FUNCTION
in the display.
2 Select
A-PI
Pressing 5/∞ will switch
off and that status will be displayed (e.g.,
).
A-PI :ON
to select
FM STEP
repeatedly until
FM STEP
to select .
A-PI
repeatedly until
A-PI
on or off with 5/∞.
between on and
A-PI
.
appears