Setting The Time For Dimmer; Changing The Display Color - JVC KD-DV7401 Bedienungsanleitung

Category Indication
Amp Gain
Amplifier gain
control
Rear Spk *
9
Rear speaker output
Color Sel
Color selection
Color Set
Color setting
Red
Green
Blue
Key Illum
Illumination switch
*
9 Displayed only when Dual Zone is activated (see page 27).
* 10 Depends on the "Dimmer" setting.

Setting the time for dimmer

• When is shown on the display, you can
move back to the previous screen by pressing number
button 3.
1
Follow steps 1 to 3 on page 45.
• In step 2, select "DISP."
• In step 3, select "Dimmer."
2
Select "Time Set."
48
Item Setting, [reference page]
( : Initial)
• High PWR : Volume 00 – Volume 50
• Low PWR : Volume 00 – Volume 30 (Select if the maximum power of each
speaker is less than 50 W to prevent damaging the speaker.)
• On : Select this to turn on the rear speaker output.
• Off : Cancels.
Initial: All : Select your favorite display color for each source (or for all
Source; sources), [48, 49].
Color: Pale
— : Create your own colors, and select them for the display color,
[49].
: User color during the day time *
Day Color
: User color during the night time *
NightColor
00 — 11 : Initial: Day Color: 07, NightColor: 05
00 — 11 : Initial: Day Color: 07, NightColor: 05
00 — 11 : Initial: Day Color: 07, NightColor: 05
• Red : You can select some of the buttons illumination according to
• Green your preference.
3
4
You can select your favorite display color for each source
(or all sources).
• When
10 .
10 .
Adjust the dimmer start time.
1
Turn the control dial to set the dimmer start
time.
¢
2
Press to select "To." Then, turn the
control dial to set the dimmer end time.
Exit from the setting.

Changing the display color

is shown on the display, you can
move back to the previous screen by pressing number
button 3 or 6.