Cleaning And Care - Klarstein Kristall XL Bedienungsanleitung

EN
16
Operation
1 Open the lid, remove the transparent tank and add water. Replace the tank and
replace the lid.
Note: There is a water outlet hole above the water tank. The filled water
should not exceed this position. If more water is added, the excess water
will drain off automatically.
2 Connect the power, the screen lights up and the appliance is in standby mode.
3 Select the size of the ice you want to produce. Large ice cubes (L) are set by
default.
4 Press Start/Stop to start the machine and start making ice cubes.
Important Notes
• The water poured into water reservoir should be lower than the water reservoir's
MAX position. When water volume goes beyond the max, please open the bottom
water drain plug to drain the spare water out. Then close the transparent lid.
• Please select the small ice when ambient temperature is below 20°C. When the
ambient temperature is higher than 25°C, Large ice cube sizes are recommended.
• When the ice basket is full please remove the ice immediately, Do not allow the ice
Basket to overfill. When the ice basket is full enough, you can take out the up water
box, and take out a part of ice, you can take out the ice basket.
• Before making ice, do put the ice basket in the ice maker.

CLEANING AND CARE

• Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator
frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of the
Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.
• Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommended by the manufacturer.
• To ensure the cleanness of ice, please change water for water reservoir at least once
one day. If do not use for a long time, please drain the water out and clean it up.
• If the compressor takes a strike action for shortage water, fully water or interruption
of power supply, it will delay for 3mins to start up after restarted.
• Always use fresh water before starting ice production either at initial installation or
after a long shut-off period.