Cleaning And Care - Klarstein Eiszeit 10033478 Bedienungsanleitung

CLEANING AND CARE

1. Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator
frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of the
Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate
the defrosting proces, other than those recommended by the manufacturer.
3. If the icemaker is reused after a long time, the water pump may not pump sufficient
water due to an air block, the deficient water indicator turns on in this case . To
correct this press the START button again, then the icemaker will work normally.
Note: To ensure the cleanliness of the ice cubes, water in the water reservoir should
be replaced every 24 hours.
4. If the compressor stops for any reason such as water shortage, too much Ice, power
off, etc... Do not start the system right away, wait 3 minutes, and then re-start the Ice
maker.
5. Always use fresh water before starting ice production either at initial installation or
after a long shut-off period.
6. This unit is for home use only,not for outdoor use,if it is necessary for use
outside,please make sure the view window is closed.
Note: We recommend a filter in regions with high calcareous water content.
EN
19