Klarstein Kristall XL Bedienungsanleitung Seite 17

TROUBLESHOOTING
Problem Possible cause
The device is The voltage is too low.
exceptionally loud
and humming.
The water indicator There is too little water in
goes on. the tank.
The float has not been
installed correctly.
The float switch is broken.
The indicators on The fuse is broken or the
the control panel unit is switched off.
do not light up.
The ice cubes are The water temperature is
too large and stick too low.
together.
There is ice from the last
run in the water bowl.
The device is Problem with the coolant.
running but does
The compressor is broken.
not produce ice.
The fan motor is damaged.
All lights flash Since ice has no contact
simultaneously. with the ice bar.
The moving detection
mechanism on the ice bar
is broken.
The ice reaches the The movable detection
ice bar but the ice mechanism on the ice bar
container display is broken.
does not start.
The display is broken.
Suggested solution
Stop the unit and plug it into
an outlet that has the specified
voltage.
Top up with water.
Contact a specialist company.
Replace the fuse or switch on the
appliance.
Select small ice cubes.
Switch to standby mode and
remove the ice.
Contact a specialist company for
inspection and repair.
Disconnect the plug and restart
the appliance.
Contact a specialist company.
Contact a specialist company for
inspection and repair.
EN
17