Basic Settings - Emos St201 Bedienungsanleitung

The terminals on PCB can be used to connect the power supply and
the controlled device.
• Heating
• Cooling:
• Heating with PWM

Basic settings

The switches on PCB can be used to turn on or off of below functions.
Terminal Function
COM Common
NO Normal Open
NC Normal Close
38
Switch Function OFF
C/H Heat /cool system Heat (Default)
ON-OFF
PWM Control mode
Control (Default)
7D/5-2D Programming day 5-2 days (Default)
Temperature
F/C Celsius (Default)
Scale
The switches SPAN1 and SPAN2 on PCB use to select the SPAN as per below table.
The factory default setting for all these functions are listed on above table.
Switch
SPAN2 SPAN1
OFF (Default) OFF (Default)
OFF ON
ON OFF
ON ON
DIP switch label
ON DIP Switch OFF
P 7d P 5/2d
1 0
1 0
°F °C
PWM ON/OFF
Cool Heat
Precautions
This product is engineered to give you years of satisfactory service if you handle it
carefully. Here are a few precautions:
1. Please keep out of reach of children.
2. Do not clean the unit with abrasive or corrosive materials. They may scratch the
plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust, temperature or humidity, which may
result in malfunction, shorter electronic life span, damaged battery and distorted parts.
ON
Cool
PWM Control
7 days
Fahrenheit
Control mode
ON-OFF
PWM Control
Control
1 °C/ 20 °F,
0.5 °C/ 10 °F
300 seconds
2 °C/ 40 °F,
1.0 °C/ 20 °F
300 seconds
1 °C/ 20 °F,
1.5 °C/ 30 °F
300 seconds
2 °C/ 40 °F,
2.0 °C/ 40 °F
300 seconds
Response
1 1 0 0
1 0 1 0
Slow . . . Fast
39