Conversion To Another Type Of Gas; Commissioning; Troubleshooting; Replacing Components - Modular 70/40 CPE Installation, Gebrauch, Wartung

standards and the instructions in this manual.
16. CONVERSION TO ANOTHER TYPE OF
GAS
See Chapter " Instructions for installation ".
17.

COMMISSIONING

See Chapter " Instructions for installation ".
18.

TROUBLESHOOTING

GAS PASTA COOKER
THE PILOT BURNER DOES NOT LIGHT.
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Igniter defective or not properly connected.
- Igniter or igniter wire defective.
PILOT BURNER GOES OUT DURING USE.
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
- The gas cock and/or gas valve knob is not being
pressed enough.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
- Defective pressure switch.
- Defective energy regulator.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Defective energy regulator.
ELECTRIC PASTA COOKER
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Defective heating element.
- Defective energy regulator.
- Defective pressure switch.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Defective energy regulator.
19.

REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
25