Positioning; Connections - Modular 70/40 CPE Installation, Gebrauch, Wartung

- Check the state of the packing and in the event of
damage, ask the delivery person to inspect the
goods.
- Remove the packing.
- Remove the protective film from the outer panels.
Use a suitable solvent to remove any residual
adhesive from the panels.
6.

POSITIONING

The overall dimensions of the appliance and the
position of connections are given on the
installation diagram at the end of this manual.
The appliance can be installed singly or in
combination with other appliances in the same
product range.
The appliance is not suitable for integrated
installation.
Position the appliance at least 10 cm from adjacent
walls.
If the appliance is to be be placed near walls,
dividers, kitchen furniture, decorative elements
etc. this must be made of non-combustible
materials
Otherwise, they must be covered with suitable
non-combustible heat insulating materials.
Level the appliance by means of the height-
adjustable feet
APPLIANCE ASSEMBLY WITH BASE, BRIDGE AND
CANTILEVER SOLUTIONS
Follow the instructions provided with the type of
support utilized.
FIXING THE APPLIANCE TO THE FLOOR
If the appliance is installed alone, check if it needs
to be fixed to a top or to the floor. (TAB 5)
Secure the appliance to the floor one by one using
the adjustable feet, flanged or specific bracket
For single models refer to the technical data tables
at the bottom of this manual and to the Illustration
section.
JOINING APPLIANCES TOGETHER IN LINE
Remove the control panels (A).
Remove the fixing screw nearest the panel from
eachof the sides to be joined (B).
Place the appliances side by side and adjust the
tops to the same height. (C)
Insert the (supplied) connector platein the seat
provided on the side of the top. Join the appliances
by screwing down the connector plate using the
the flat-headed M5 screws (supplied). (D)
Turn one of the two internal tabs of the appliances
to be joined by 180°. (E)
Join the appliances by screwing the M5x40 screw
on the opposite insert. (E)
FUMES EXHAUST SYSTEM
Create a fumes exhaust system based on the "
Type " of appliance. The " Type " is stated on the
appliance dataplate.
" A1 " TYPE APPLIANCE
Position the "A1" type appliance below an
extractor hood to ensure smoke and fumes
generated by cooking are removed.
" B21 " TYPE APPLIANCE
Position the "B21" type appliance below an
extractor hood.
" B11 " TYPE APPLIANCE
Fit the "B11" type appliance with a suitable fl ue,
available from the appliance manufacturer. Follow
the assembly instructions provided with the flue.
Connect the flue to a 150/155 mm diameter hose,
heat resistant to 300°C.
Vent to the outside or into an effi cient fl ue. The
hose length must not exceed 3 metres.
7.

CONNECTIONS

The position and dimensions of connections are
given in the installation diagram at the end of this
manual.
CONNECTION TO THE GAS SUPPLY
- Check that the appliance is designed to operate
with the type of gas supply present on site. Check
the information given on the decals on the packing
and appliance.
18