Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
● Cleaning the device after each use is recommended.
●
Do not use water or any other liquid for cleaning.
●
Clean the reciprocating saw with a dry cloth or blow with compressed air at low pressure. Do not use
any cleaning agents or solvents, they may damage plastic parts.
●
Clean ventilation holes in the motor casing regularly to prevent device overheating.
●
In case of excessive commutator sparking, have the technical condition of carbon brushes of the motor
checked by a qualified person.
●
Store the reciprocating saw in a dry place, beyond reach of children.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always replace
both brushes at a time.
●
Unscrew and remove carbon brush covers (
●
Remove worn out carbon brushes
●
Remove any carbon dust with compressed air.
●
Insert new carbon brushes. Brushes should easily move into brush-holders.
●
Fix carbon brush covers (
After the brushes are replaced start the mitre saw with no load and wait until the brushes fit to the
motor commutator. Entrust replacement of carbon brushes only to a qualified person. Only original
parts should be used.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Supply voltage
Input current frequency
Rated power
Blade stroke cycles (without load)
Maximum thickness of cut material
Blade stroke length
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp
= 89,7 dB(A) K = 3 dB(A)
A
Sound power: Lw
= 100,7 dB(A) K = 3 dB(A)
A
Vibration acceleration: a
h
Do not dispose of electrically powered products with household wastes, they should be utilized in
proper plants. Obtain information on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in natural environment. Unrecycled
equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna
2/4 (hereinafter Grupa Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not
limited to, text, photographies, schemes, drawings and layout of the instruction, belong to Grupa Topex exclusively and are
protected by laws accordingly to Copyright and Related Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach
pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments). Copying, processing, publishing, modifications for
commercial purposes of the entire Instruction or its parts without written permission of Grupa Topex are strictly forbidden
and may cause civil and legal liability.
3).
.
3).
TECHNICAL PARAMETERS
Reciprocating Saw
Parameter
Wood
Steel
2
= 12,576 m/s
K = 1,5 m/s
ENVIRONMENT PROTECTION
230 V AC
0 – 2500 spm
180 mm
2
12
Value
50 Hz
1100 W
20 mm
29 mm
II
3,9 kg
2014
Werbung
Inhaltsverzeichnis
