Cleaning And Maintenance - Concept MM4310 Bedienungsanleitung

EN
MEAT BALL PREPARATION
Assembly of the adapter for the preparation of meat balls
1. Insert the auger into the grinder body.
2. Attach the extruder disc and the cap for preparation of meat balls onto
the auger axis.
3. Make sure that the securing groove on the extruder disk engages in the
pin on the grinder body.
4. Tighten the grinder nut.
5. Attach the assembled grinder body to the motor unit. Push the grinder
body at a 45° angle to the motor unit and turn the grinder body counter
clockwise until you hear a click. Check if the adapter is properly fastened
and cannot be released and removed without using the lock button.
6. Check the tightening of the grinder nut.
7. Place the hopper on the grinder mouth.
8. Now the appliance is ready for use.
Note: This accessory is used without replaceable discs and without a cross-
blade knife. Prepare a meat mixture, that should be well minced, flavoured
and mixed.
Put the mixture gradually into the inlet of the appliance.
Do not push too hard, otherwise the appliance may get clogged.
9. Shape the extruded mixture to your liking.
10. When you are done with processing, you can push out any residues
from the adapter by inserting and processing a few pieces of bread.
11. After processing, switch off the appliance by pressing the on/off button
and disconnect it from the electrical outlet.
12. To release the adapter from the holder, keep pressing the lock button
and simultaneously rotate the adapter clockwise to release it.
13. Loosen the grinder nut to disassemble the adapter.
50
This appliance is equipped with a thermostat. This system automatically interrupts the power supply of the appliance
in the event of overheating.
If your device suddenly stops:
1. Disconnect the power cord from the socket.
2. Press the On/Off switch to turn the appliance off.
3. Allow the appliance to cool down for 60 minutes.
4. Reconnect the power cord.
5. Switch on the appliance.
Contact an authorized service centre if the thermostat gets activated too frequently.
NOTICE: To avoid a hazardous situation, do not connect this appliance to the timer switch.
TIPS
The power cord can be stored in the storage compartment located at
the bottom of the appliance
If the auger gets clogged with a foodstuff, turn off the motor
immediately and use the reverse gear to release it. If the auger is
clogged, it may damage the motor.
The pusher is hollow so it can serve as a storage for other adapter parts.

CLEANING AND MAINTENANCE

Before cleaning and after use of the appliance, switch the appliance off, disconnect it from the mains and allow it to
cool down.
Do not immerse the power cord or the charger in water or any other liquid.
Wash the exchangeable accessories in warm, detergent water and rinse with clean water.
Wipe the surface of the appliance with a damp cloth.
Do not use pot scourer, abrasives solutions or solvents for cleaning.
Prior to assembling, let all parts to dry properly.
After cleaning, grease the discs and cross-blade knife with vegetable oil to prevent rust or surface oxidation.
MM4310 MM4310
EN
51