Inhaltsverzeichnis
Werbung
Filter replacement
Filter replacement
Do not spread dust during filter replacement!
Do not spread dust during filter replacement!
- Wear adequate filter mask;
- Wear adequate filter mask;
- detach the vacuum head pushing the side hooks (11) (pic.7-8);
- VERSION "M": seal the dust container with the appropriate cap (33);
- turn the vacuum head upside down (pic.15);
- detach the vacuum head pushing the side hooks (11) (pic.7-8);
- remove the filter frame (21) turning the hooks (22) (pic. 16);
- turn the vacuum head upside down (pic.15);
- remove the filter frame (21) turning the hooks (22) (pic. 16);
- remove the filter cartdridges (pic. 17) and fit them into a se-
- remove the filter cartdridges (pic. 17) and fit them into a sealed disposal bag;
aled disposal bag;
- fit new filter (cod. 036.1108) cartridges in the filter frame (pic.18) and reassemble it on the
- fit new filter cartridges in the filter frame (pic.18) and reas-
vacuum head.
semble it on the vacuum head.
Use genuine RUPES spare parts only.
Refer to www.rupes.com for parts code and authorized service centre
RUPES Spa. will not be held responsible for direct or indirect damages resulting from
non-compliance with the requirements of this manual.
TROUBLESHOOTING AND SOLUTION
Effects
The motor will not start
The vacuum does
not start automatically
Vacuum flow is insufficient
Dust from the exhaust (10)
Tools do not start
Insufficient Power for pneumatic tool
Red indicator on
Yellow indicator on
TOOL IDENTIFICATION PLATE
DISPOSAL (WEEE DIRECTIVE)
POSITION AND MEANING OF INFORMATION
1. Type of tool.
2. Nominal working voltage Volts (V).
3. Working frequency Hertz (Hz).
4. Class of protection.
5. Absorbed power Watt (W).
must be collected separately, in order to be recycled in an en-
6. Power at socket (MAX) Watt (W).
vironmentally friendly way. The product, when it reaches the
7. Power max Watt (W).
end of its life, must not be dispersed in the environmentor
8. Serial number.
thrown away as household waste. It must be disposed at au-
9 .
Read all this instructions before operating this product and save these in-
thorized recycling centres (contact your local authorities to
structions.
know where to dispose of the product according to the law).
The correct disposal of the product contributes to the health
1 0 .
and preservation of the environment.
2002/96/CE (WEEE) + 2003/108/CE and its implementation in national law, must not
be released into the environment or thrown away as domestic waste, but must be
Illegal disposal of the product will entail penalties against the
disposed of at authorised recycling centres (contact the
offenders.
for a list of places where the product may be disposed of according to the law).
Disposing of the product correctly contributes to protecting human health and safe-
guarding the environment. Any illegitimate disposal of the product will be punishable
by law.
Causes
No power
Power cord, switch or
motor defective
Electronic module
Bag full
One of the hoses or
accesso ries is clogged
Clogged filters
Filter cartridge torn ripped
3-way switch malfunction
Insufficient compressed air feeding
Ordinary maintenance limit exceeded
Max. liquid level exceeded
For EC countries only: According to the European
Directive on Waste from electrical and electronic
equipment and its implementation in conformity with
national standards, exhausted electrical equipment
At the end of its useful life, the product, pursuant to European Directive
Solutions
Make sure the unit is plugged in
Contact an authorised service centre
Contact an authorised service centre
Check the filter bag
Check the flexible hose and the
accessories
Check the filters cartridges
Contact an authorised service centre
Contact an authorised service centre
Check air passage
Contact an authorised service centre
Empty the bin
relevant local authorities
12
11
Werbung
Inhaltsverzeichnis
