Using The Sleep Timer; Tone Control (Remote Control Only); Adjusting Brightness Of Front Panel Display - Yamaha ISX-803 Bedienungsanleitung

You can set the time until the system automatically enters standby mode.
Top panel
AUTO 2
1
DIMMER
USB
VOLUME SOURCE ALARM
1

TONE CONTROL (REMOTE CONTROL ONLY)

Remote control

ADJUSTING BRIGHTNESS OF FRONT PANEL DISPLAY

Rear panel

USING THE SLEEP TIMER

SET 2 BEEP SOURCE + BEEP
1 SOURCE
CLOCK ALARM TYPE
LABEL SIDE
SNOOZE SLEEP PRESET
3
2
1
2 1 AUTO
1
Press SNOOZE/SLEEP a number of times to set
the time until the system enters standby mode.
The sleep timer can be set to 30, 60, 90 and 120 minutes.
When the time is set, the sleep indicator (
front panel display.
y
If you press SNOOZE/SLEEP while the sleep timer is activated, the
sleep timer setting will be canceled.
1
Press one of the LOW/MID/HIGH EQ buttons on
the remote control while playing back.
Select the tone to be adjusted (LOW, MID, HIGH).
2
Press to adjust the tone.
/
Each tone can be adjusted from –5 to +5.
3
Press to complete settings.
You can also press the EQ button that you pressed in Step 1
to complete the settings.
To change the tone of other frequency band, return to step 1
and press the EQ button to adjust the desired tone.
1
Adjust the brightness with the DIMMER switch on
the rear panel.
AUTO: adjusts the brightness automatically to match the
surroundings.
1: brighter.
2: darker.
Note
When AUTO is set, the brightness of the front panel display is adjusted
automatically with the illumination sensor (☞ P. 3). Ensure that the
sensor is not covered.
) is shown on the
Tone
: HIGH
Tone
： MID
Setting
： LOW
21
En