Before First Use; Disassembling The Product - Silvercrest 313492 Bedienungs- Und Sicherheitshinweise

ingredients which are impeding
the mixing paddle
If maintenance is required, please
contact the service point.
Before each use, please check
the mains cable
mixing chamber
paddle and the other remov-
5
able parts for damage. If you
find damage, please contact the
service address for a replacement.
To prevent hazards, ensure that
all elements have been fixed in
the correct place before you con-
nect the product to the power
supply.
Do not use the microwave or
other sources of heat to disinfect
the product. This could cause
deformation and defects.
Do not clean the product with
steel wool, scouring agents or
corrosive liquids.
Do not expose this device to
sunlight for prolonged periods.
This could cause decolouration.
Do not heat any parts of this
product.

Before first use

To prevent hazards, make sure that the device
is complete and the device, mains plug and
38 GB/MT
.
5
, the plug, the
3
, the mixing
1
mains cable are in good condition after
3
unpacking to rule out possible damage.
The device is packaged to protect it from trans-
port damage.
Carefully remove the device from the retail
packaging.
Remove all parts of the packaging and remove
the protective film from the display.
Thoroughly clean the device and all accessories
as specified in chapter „Cleaning and care".
To do so, you will first have to disassemble the
device. Follow the instructions in the chapter

„Disassembling the product".

After it has been thoroughly cleaned and re-as-
sembled (see chapter „Assembly"), set up the
pasta machine in the vicinity of a safety socket.
Make sure it is easily accessible.
Furniture nowadays is coated with a variety of
varnishes and plastics, and is treated with the
most diverse of care products. It is therefore im-
possible to rule out that some of these substances
may contain components which would attack
and soften the rubber feet of the housing
necessary, place an anti-slip pad under the
pasta machine.
Place the device on a suitable surface.
Connect the mains cable
the back of the device.
Connect the device to the safety socket.
Disassembling the product
Make sure that the device is switched off and
unplug the mains plug from the socket before
disassembling.
Remove the lid from the housing
4
erating the release catch and then pulling the
lid upwards using the handle.
4
Turn the shaping disk holder
and remove it from the pressing tube
Unscrew both fixing screws
anticlockwise at the same time, until the front
panel can be removed from the housing
6
without difficulty.
Pull the pressing tube including the auger
out of the mixing chamber
7
. If
2
with the socket on
3
by op-
2
anticlockwise
9
.
8
by turning them
15
2
8
.
1