Troubleshooting; Disposal - Silvercrest 313492 Bedienungs- Und Sicherheitshinweise

Troubleshooting

Problem
The pasta machine has no power. The plug is not inserted or
The pasta machine is not pressing
out any pasta or "E1" has ap-
peared in the LC display
The pastas have ridges or cracks. Due to the mixing at the
The shaping disks are difficult
16
to clean.
The pastas break when they
come out.
In the event of malfunctions not specified here, please
contact our Customer Service Department. Our
customer service representatives will gladly assist
you. The service address is listed with our warranty
terms.
Cause
has poor contact.
Not enough liquid
.
2a
Too much liquid
beginning and the pressing
out at the end, the pastas
have more ridges or cracks.
The dough is moist.
Not enough liquid
Solution
Clean the plug with a dry cloth
and / or insert this into the socket
(again).
Pour in small quantities of liquid
through the opening in the lid
press the knead button
the ON / OFF button
and then again to switch it on again,
then push the press out button
check whether pasta is being produced.
Remove the dough from the mixing cham-
ber , pick it into small pieces, put it
1
back into the mixing chamber
a little flour and then press the knead
button . Then press the ON / OFF
2c
button to switch it off, and then again
2b
to switch it on again, then push the press
out button
2e
pasta is being produced.
Add whisked eggs and the pastas will
become supple.
If you have enough time, you could
break the pastas apart to the size of
small peanuts and put them back into
the mixing chamber
knead button
out again. The more frequently you
repeat this, the softer and firmer the
pastas will become.
Allow the dough to dry in the shaping
disks and use the cleaning tool
16
Please add liquid strictly as specified in
the instructions (see chapter "Measuring
out ingredients").

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
and
4
. Then press
2c
to switch it off,
2b
and
2e
, add
1
and check whether
. Then press the
1
and press the dough
2c
14
GB/MT
.
43