Intended Use - VOLTCRAFT DT-30LK Bedienungsanleitung

2. INTENDED USE

The product is designed to measure and display rotation speed and belt speed. Measurements are
either non-contact via the built-in laser or per direct contact using the included adapters.
Rotation speed can be displayed in RPM (revolutions per minute), Hz, m/min, in/min, ft/min and yd/
min. The product can also display the total number of revolutions during measurement. The distance
of belts can be shown in m, in, ft and yd.
The measured values are shown on the 5-digit LC display. The product features a memory with
space for 40 measured values which allows the user to retrieve the maximum, minimum and
average values from a stored measuring procedure.
Power supply is via a 9 V block battery.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms,
must be avoided under all circumstances.
This product complies with the statutory national and European requirements.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. Using the
product other than for its intended purpose as described above can damage the product or pose
a risk of injury. Read the instructions carefully and keep them. Make this product available to third
parties only together with its operating instructions.
Heed all safety instructions and information in this manual.
19