Wolf Garten LI-ION POWER GTB 815 Originalbetriebsanleitung Seite 15

3
Instructions for the handling of the charger
• Red LED (5) is on: Battery is being charged.
• Green LED (5) is on: Charge process com-
pleted.
• Red LED flashing (5): Error
1
Self-discharge of batteries!
Remove the battery from the charger once it is
fully charged.
3
General instructions:
regarding the battery In order to maintain the
long service life of the battery, always follow
the instructions below:
• The lawn trimmer are automatically switched
off when the battery voltage is low. The bat-
tery must then be recharged before the
shears can be used again.
• Always recharge the lithium-ion battery pri-
or to any prolonged period of non-use, i.e.
before storing the shears away in autumn.
• The charging time is approx. 2 hours for a
completely discharged battery.
• The lithium-ion rechargeable battery can be
charged at any charge level and charging
can be interrupted at any time without dam-
aging the battery (no memory effect)
Settings
The lawn trimmer is equipped with a four-position ad-
justable working angle. This enables you to easily
trim hard-to-reach areas in your garden.To set the
ideal working position, please follow the instructions
below.
3
The cutting head should be inclined slight-
ly forward while trimming.
Working angle
Free trimming - Working angle 1 and 2
During free trimming, you should swing the trimmer in
a semi-circular motion in front of your body.
G
• Set working angle
Trimming under bushes / on slopes - Working
B
angle 3
G
• Set working angle
en
A
.
.
Edge function (horizontal cut) - Working angle
4 C
The edge function enables precise and convenient
trimming along the edge of the lawn.
1. Turn cutting head 90°
2. Set working angle
Plant hoop guard
The plant hoop guard protects bushes, trees and
L
plants (1). When edging, the plant hoop guard
must remain in the position illustrated in
Telescoping handle and grip
The trimmer is adjusted to your body height by means
of the telescoping handle and the middle grip
K
.
On / off switch
F
1
Caution! Spinning strands
Tool continues spinning after switching off!
Switching on the device
• Press and hold down the on/off switch.
Switching off the device
• Release the on/off switch.
Thread adjustment
The thread is adjusted with the tilt switch. Briefly tilt
the running machine on a firm base, e. g. paving slab
(approx. 3 kg pressure). Approx. 2,5 cm cutting
thread are the automatically paid out.
3
Tips on trimming
• Cut high grass slowly, step by step.
• You can prolong the life of your trimmer by
removing grass from the ventilation slots and
the bottom of the trimmer be-fore or after
each use.
• In order to take full advantage of the battery
capacity, you should not switch the trimmer
on and off unnecessarily.
H
.
G
.
L
(2)
(3)
L
(2).
J
15