Mounting Accessories - Ferm ATM1043 Bersetzung Der Originalbetriebsanleitung

Special safety instructions
• Avoid too high pressure
• Keep bystanders and pets away
• Children and animals should be kept far away
from the area of operation of the machine.
• If the compressor is no longer in use, always
take the plug out of the plug socket.
• Always make sure that compressed-air
hoses are used for compressed air and which
are characterized by a maximum pressure
adjusted to that of the compressor. Do not try
to repair the hose if it is damaged.
Additional safety instructions
• Preferably wear safety glasses.
• Do not use the tool in a work area where stairs,
ladders or scaffolding are involved.
• Use accessories with adequate speed rating.
• Never aim the air flow at people or animals.
• Be cautious when using compressed air.
• Only use clean and dry compressed air as a
power source for the tool. Never use oxygen or
a combustible gas.
• Do not exceed maximum operating pressure.
• Keep the tool clean. Do not use any aggressive
or alcohol-based cleaner.
• Never use gasoline or other flammable liquids
to clean the tool. Vapours in the tool will ignite
by a spark and cause the tool to explode.
• Disconnect the tool from the air supply before
troubleshooting or servicing, or during non-
operation.
• Only carry the tool at the grip and never with
the trigger actuated.
• Never carry the tool by the air hose or pull the
air hose to move the tool.

3. MOUNTING ACCESSORIES

Connecting and removing the air hose
Fig. B
• Wrap a piece of sealing tape around the
connecting piece (7) of the air hose.
• Fit the connecting piece of the air hose into the
connection (3).
• Check whether the air hose is connected
properly.
Mounting a socket
Fig. C & D
• Fit a socket onto the accessory holder (4).
• Firmly press the socket onto the accessory
holder.
Adjusting the impact force
Fig. E & F
• Turn the adjusting knob (2) counterclockwise
to increase the impact force.
• Turn the adjusting knob clockwise to reduce
the impact force.
1 - 190 Nm
2 - 220 Nm
3 - 260 Nm
4 - 310 Nm
Changing the direction of rotation
Fig. A
• Push the forward/reverse switch (6) forward for
clockwise rotation.
• Push the forward/reverse switch backward for
counterclockwise rotation.
• Tighten the screw.
4. USE
Instructions for use
• Check whether the trigger can move freely.
• Make sure that the tool is lubricated before
connecting it to compressed air.
• Check if the air hose is correctly fitted.
• Set the air pressure to a value within the
allowable operating pressure.
• Only keep your finger on the trigger at the
moment of starting the tool.
Switching on and off
• To switch on the tool, press the trigger switch (1).
• To switch off the tool, release the trigger
switch.
Tightening and loosening fasteners
Fig. A, C & D
• Fit a required socket.
• Select the direction of rotation.
• Place the tool on the fastener.
• Switch on the tool.
• If necessary, adjust the impact force.
5