Removing The Unit - Kenwood DPX-7200DAB Bedienungsanleitung

Installation/Connection

Removing the unit

1
Fit the catch pin on the extraction keys into the holes on both sides of
the trim plate, then pull it out.
2
Insert the extraction keys deeply into the slots on each side, then
follow the arrows as shown on the illustration.
Connect external components
No Part
1 Microphone input jack (Page 18)
2 Output terminals (See the following "Connect external amplifiers via output
terminals".)
3 DAB antenna jack (Page 7, 37)
Connect external amplifiers via output terminals
When connecting an external amplifier to the output terminals of this unit,
securely connect the amplifier ground wire to the car chassis to prevent
damage to the unit.
Output terminals 2-way crossover
REAR: Rear output
FRONT: Front output
SW: Subwoofer output
3-way crossover
Tweeter output
Mid Range output
Woofer output
33
ENGLISH