Terminal Assignment - Kübler Sendix S3674 Betriebsanleitung

Kübler Group

4.2.4 Terminal Assignment

Interface Interface in-
digital cremental
1 (BiSS) 1 (SinCos)
Suitable pre-assembled
cordset, 10-wire
(8.0000.D111.0M50)
Interface Interface in-
digital cremental
2 (RS485) 1 (SinCos)
Suitable pre-assembled
cordset, 8-wire
(8.0000.D112.0M50)
Interface Interface in-
digital cremental
1 (BiSS) A (none)
Suitable pre-assembled
cordset, 6-wire
(8.0000.D113.0M50)
+V: Encoder supply voltage +V DC
0 V: Encoder ground GND (0V)
D+, D-: Data signal
C+, C-: Clock signal
A, A\: Incremental output Channel A (Cosine)
B, B\: Incremental output Channel B (Sine)
RS485 specifies a standard voltage range for the slave supply of 7 ... 12 V DC (including the tol-
erances). The supply voltage is measured on the slave; the maximum voltage drop over the
cable length must be considered accordingly when dimensioning the master supply.
RS485 specifies a maximum current consumption by the slave of 250 mA at 7 VDC.
BA S36xx - R60071.0009 - 01
Type PCB connector (male), 10-pole
of
con-
nec-
tion
1 Signal: 0 V +V D+
Pin: 1
Wire BU RD GY GN YE VT PK BK WH BN
color:
Type PCB connector (male), 10-pole
of
con-
nec-
tion
1 Signal: 0 V +V D+
Pin: 1
Wire BU RD GY GN
color:
Type PCB connector (male), 10-pole
of
con-
nec-
tion
1 Signal: 0 V +V D+
Pin: 1
Wire BU RD GY GN YE VT
color:
D- C+ C-
2 3 4 5 6
D- - -
2 3 4 5 6
- -
D- C+ C-
2 3 4 5 6
4 Installation
A A\ B B\
7 8 9 10
A A\ B B\
7 8 9 10
PK BK WH BN
- - - -
7 8 9 10
- - - -
EN - 37