General Information For The Mounting Of Encoders - Kübler Sendix S3674 Betriebsanleitung

4 Installation

4.1.1 General Information for the Mounting of Encoders

Note the following:
ATTENTION
ATTENTION
ATTENTION
ATTENTION
30 - EN
Do not disassemble or open the encoder
Encoder function may be lost partly or entirely.
• In no case disassemble the encoder entirely or partly.
• Do not open the encoder. Otherwise, the warranty will be void.
Do not modify the encoder and do not change the shaft
Encoder accuracy will be impaired and the function of the bearings
and seal may be lost partly or entirely.
• Do not machine the shaft or the housing subsequently (e.g. grind-
ing, sawing, drilling, etc.).
Do not subject the encoder to shocks or overload it
This would impair encoder accuracy and bearings and seal reliability.
• Do not use a hammer to align the encoder.
• Absolutely avoid impact stress.
• Do not subject the encoder shaft to axial or radial loads exceeding
the values specified in the data sheet.
Do not connect rigidly the stator and the rotor
The encoder would be mechanically constrained and thus damaged.
• With solid shaft encoders, always use a tolerance-compensating
element between the drive shaft and the encoder shaft.
• With hollow shaft encoders, always use a tolerance-compensating
element between the encoder flange and the drive flange.
Kübler Group
BA S36xx - R60071.0009 - 01