Electrical Installation; General Information For The Connection; Information For Emc-Compliant Installation - Kübler Sendix S3674 Betriebsanleitung

Kübler Group

4.2 Electrical Installation

4.2.1 General Information for the Connection

ATTENTION
NOTICE
NOTICE
NOTICE

4.2.2 Information for EMC-Compliant Installation

Wiring
When wiring the facility, pay attention to proper cable routing.
• Separate the wiring into power groups such as motor/power supply lines and signal and data
lines.
BA S36xx - R60071.0009 - 01
Destruction of the device
Before connecting or disconnecting the signal cable, always discon-
nect the power supply and secure it against switching on again.
General safety instructions
Make sure that the whole plant remains switched off during the elec-
trical installation.
• Make sure that the operating voltage is switched on or off simultan-
eously for the encoder and the downstream device.
• Electrostatic discharges at the contacts of the connector or at the
cable ends could damage or destroy the device. Take appropriate
precautionary measures.
• Use a PELV supply voltage source according to EN 60204-1 com-
plying with the proper operating voltage and the maximum permiss-
ible output current.
Other operating instructions applicable for the installation
To connect the encoder, refer to the corresponding operating and
safety instructions of the external drive system / encoder evaluation
system.
When assembling a mating connector, comply with the instructions
attached to the connector.
No open cable wires
Make sure that all required cable wires / connectors are connected
before commissioning. Insulate individually all unused ends of the
output signals to avoid short-circuits.
4 Installation
EN - 35