Self-Diagnosis; Out Of Range - Santec SLS-1505D Bedienungsanleitung

Bedienungsanleitung / User Manual
SLS-1505D, SLS-1705D, SLS-1905D, SLS-2150D, SLS3200D, SLS-4200D

4. Self-diagnosis

If there is no image, the self-diagnosis screen will be displayed. The self-diagnosis function
checks if the status of the monitor screen is „No Signal", „Out of Range" and „Power off"
message.
N O - S I G N A L
A "No Signal" screen is displayed when the D-sub signal connector is connected but the
status of the monitor is on DPMS mode.

OUT OF RANGE

A „Out of Range" screen is displayed when the applied frequency is under or over normal
range.
Normal range (non-interlaced mode only):
H: 30 to 80 kHz
V: 56 to 77 Hz
Press any key to cancel.
The monitor is turned off when it did not receive any signal from remote control or any button
within the time that you set up.
_________________________________________________________________________________
- 47 -