Geometry (Only In Vga Mode) - Santec SLS-1505D Bedienungsanleitung

Bedienungsanleitung / User Manual
SLS-1505D, SLS-1705D, SLS-1905D, SLS-2150D, SLS3200D, SLS-4200D

3.3 Geometry (only in VGA mode)

H-position:
Adjust the position of the display horizontally (left or right).
V-position:
Adjust the position of the display vertically (up or down).
Clock:
Using the "clock" signal, the image can be adjusted in a way that
vertical bars/stripes are reduced or minimized. This is achieved by
aligning the clock pulse with the received pixels.
Phase:
Reducing or minimizing the horizontal bars/stripes and noise.
Hence the image sharpness can be adjusted. This is achieved by
aligning the phase length with the received pixels.
Diagram to illustrate the adjustment of phase and clock:
_________________________________________________________________________________
Geometry
Monitor scanning:
Clock correct, phase not ideal.
Resulting image:
Some few deviations. Can be recognized as
flickering.
Monitor scanning:
Clock and phase are correct.
Resulting image:
Original image is displayed correctly.
- 43 -
Clock/pitch not correct
Phase not correct
Pixel pattern of PC
Analogue signal
Monitor scanning:
Clock not correct.
Resulting image:
Deviations.