Safety Measures - Vitek VT-1451 ST Bedienungsanleitung

BLENDER VT-1451 ST
The blender set is intended for whisking, mix-
ing, chopping or combined processing of liquid
and solid products and making potato mash.
DESCRIPTION
Detachable blender attachment
1.
Motor unit
2.
Turbo mode on button «TURBO»
3.
ON/OFF button «I»
4.
Speed control knob
5.
Chopper bowl
6.
Chopping knife
7.
Geared lid
8.
Whisk gear
9.
Whisk attachment
10.
Measuring cup
11.
Potato mash making attachment
12.
Attention!
For additional protection it is reasonable to
install a residual current device (RCD) with
nominal operation current not exceeding
30 mA. To install RCD contact a specialist.

SAFETY MEASURES

Before using the unit, read these instructions
carefully and keep them for future reference.
Use the unit for intended purposes only, as
specified in this manual.
Mishandling the unit can lead to its breakage
and cause harm to the user or damage to his/
her property.
•
Before connecting the unit to the mains,
make sure that the voltage specified on the
unit corresponds to your home mains volt-
age.
• Never leave the unit connected to the mains
unattended.
• Always unplug the unit before changing the
attachments.
• Before using the unit, make sure that the
attachments are set properly.
• Do not connect the motor unit to the mains if
the attachments are not installed.
•
The blender set allows quick and effective
operation, but continuous operation time
should not exceed 1 minute while using
the blender attachment and the whisk and
15 seconds while chopping hard products in
the chopper bowl. Make at least a two-min-
ute break between operation cycles.
VT-1451.indd 3
• It is not allowed to switch the unit on with-
out attachments and products for pro-
cessing.
• Do not use the unit outdoors.
• Cool down hot products before putting
them into the measuring cup or the chopper
bowl.
• Do not place the chopper bowl and the mea-
suring cup into a microwave oven.
• Use only the attachments supplied.
• Before using the unit for the first time,
thoroughly wash all the removable attach-
ments and containers that will contact
food.
• Place the chopper bowl on a flat stable sur-
face.
• Products should be put into the chopper
bowl before the unit is switched on.
• Do not overfill the chopper bowl with food
and watch the level of poured liquids.
• The cutting blades of the chopping knife and
of the blender attachment are very sharp
and dangerous. Handle these attachments
very carefully!
• If rotation of the chopping knife is hindered
during the chopper operation, unplug the
unit and carefully remove products that pre-
vent blade rotation.
• Remove food and pour out liquids from the
chopper bowl only after complete stop of
the chopping knife.
• Do not touch the rotating parts of the unit.
Do not let hair or free hanging clothes get
into the rotation area of the blender attach-
ment knife or whisk.
• Unplug the unit every time before cleaning
or when you are not using it.
• Unplug the unit by taking the power plug
directly.
• Do not pull the power cord and do not twist
it.
• Do not put the attachments and bowls in a
dishwashing machine.
• Do not use the unit near hot surfaces (such
as gas or electric stove, oven).
•
Provide that the power cord does not
touch sharp edges of furniture and hot sur-
faces.
• Do not touch the motor unit body, the power
cord or the power plug with wet hands.
Donot use the unit if the power cord or the
power plug is damaged.
3
ENGLISH
07.09.2015 11:36:49